Phase-On
Bypasses the phase-shift circuit for quick A/B comparison of phase effect.
Invert
Used in conjuction with the SHIFT control to access the 180º to 360º phase range.
Phase Shift
Analogue phase adjustment control used to set the phase shift from 0 ~ 180º.
Blend
Used to control the mix between the original dry signal and the wet phased effect.
Filter On
Bypasses the low-pass filter for quick comparison with the unfiltered signal path.
Filter Range
Lets you set the filter cut-off range between 3kHz ~ 38kHz or 300Hz ~3.8kHz.
Filter Cut-Off
Used to adjust the cut-off frequency of the low-pass filter.
Cable Clamp
Ties down the power supply connector wire to ensure it does not get disconnected by mistake.
15VDC Power Supply
External supply reduces noise contamination. Comes with the Phazer.
No Slip Pad
Provides electrical and mechanical isolation and keeps Phazer from sliding around.
TRS Balanced
Convenient ¼” connectors work with balanced or unbalanced sources. Ideally suited to connect to the insert point of a mixing desk.
Ground Lift
Reduces noise caused by ground loops.
XLR Output
Professional +4dB balanced line level output designed to feed the input strip of a console or recording system.
XLR Input
Balanced line level input lets you easily connect from a preamp or any other professional line level source.
14-Gauge Steel
Solid I-beam construction protects the sensitive PC board from outside stress which could cause premature part failure.
