Click to view manual

BigShot™ I/O Using & Applications

The following page describes how to use the BigShot i/o and discusses some of the functions that are built in. To view the complete manual, simply click on the icon at left.

Overview

The following page describes how to use the BigShot i/o and discusses some of the functions that are built in. To view the complete manual, simply click on the icon at left.

Following the block diagram on the left, input-1 flows directly to the toggle footswitch while input-2 is equipped with extra features to address concerns that may arise, depending on what type of instrument is being used. This includes a DIM circuit that enables the instrument to be padded down to reduce the level and a bright switch that lets you compensate for extra long cables.

Keep in mind that the i/o is completely passive and therefore requires no power or battery. This also means that it will not boost a signal. Input-2's DIM control could be used to reduce the level from an acoustic guitar with built in preamp, or active bass that would otherwise be much louder than their passive counterparts.

In instances when using two passive instruments such as maybe a Fender Strat with single coil pickups and a Les Paul with humbuckers, the single coil pickups will not be as loud as the humbuckers. This effect is often desirable and therefore, the DIM would not be used. If however you had your system set in such a way that you would want both at the same level such as during a direct recording session, you would engage the DIM and introduce the bright switch to offset the effect of the potentiometer or length of cable. The BigShot i/o is designed to suit both true bypass purists and multi-instrumentalists alike.

The BigShot i/o is also equipped with two outputs. One is designed for a tuner while the other would go to your amplifier. When the MUTE footswitch is depressed the output going to the amp is shut off to allow quiet tuning on stage. A selector switch allows the tuner to either be on all the time or be toggled so that it is only active when the footswitch is depressed. Some tuners introduce clicking noise from their quartz clock or can load down the guitar signal. For the purist, toggling the tuner when needed is preferred.