»
Click to view the JDX product 'SmartSheet' pdf
(107kb)
JDX Features and Functions
The Radial JDX Reactor is an easy to use interface
with a sophisticated internal signal path that includes
100% discreet components, Radial’s highly
acclaimed class-A signal buffering, transformer
isolation and a series of speaker emulating filters.
On board functions include input connection from
the amplifier head and throughput connection to
the speaker cabinet. A ground lift switch allows
the engineer to disconnect the earth ground from
the mixing console. A polarity reverse is also offered
that can be used to phase correct the output when
run through stage monitors or simply interface with
older gear that may not follow the current AES standard.
The Radial JDX is transformer isolated to help eliminate
buzz and hum caused by ground loops.
Housed in a 14 gauge enclosure, the JDX features
an internal I-beam construction to reduce susceptibility
of outside stress that could torque the circuit
board and reduce long term performance of the
switches and jacks. Two protective zones are created
with a unique book-end design that keeps switches
and jacks out of harms way. Finally, a full bottom
no-slip rubberized pad keeps the JDX from sliding
around on busy stages and from falling off ye
old Marshall stack when played at 11. The JDX
may be rack mounted with a Radial J-Rak or permanently
mounted on the rear panel of an amplifier or inside
a rack using the Radial J-Clamp.
| CAUTION
- THE JDX IS NOT A LOAD BOX! A speaker or
equivalent load must be connected to the JDX
'TO SPEAKER' connector at all times during
use. |
| JDX
Specifications |
 |
| Signal
type: |
Class-A, 100% discrete |
| Speaker
emulation: |
Proprietary band pass filtering with reactive
load |
| Input
level: |
Maximum 300 Watts |
| Output: |
600 Ohm electronically balanced |
| Total
Harmonic Distortion: |
0.005 % @ 1kHz |
| Power
supply: |
15VDC 400mA
power supply included |
| Construction:
|
14 gauge steel chassis and outer shell,
baked enamel finish |
| Size
(TX and RX): |
3.3"w x 5.0"d x 1.875"h
(84 x 127 x 48mm) |
Weight:
|
1.55 lb (720 g) |
| Warranty: |
Radial 3-year, transferable |
|
|
