"These devices are
outstanding. I love the fact I can remote a guitar
amp 50 meters and not
even blink. Thanks! ~
Chris 'Sully' Sullivan
(FOH - Joe Nichols)
Drive
a guitar signal 300 feet without loss 100%
discreet class-A electronics Drag
Control pickup load correction Transformer
isolated to eliminate noise Routes
using standard balanced XLR cable
The Radial SGI studio guitar
interface allows a guitar signal
to travel 100 meters (328 feet) over a standard
balanced XLR mic cable. This enables the guitarist
to play through a distant amplifier while listening
to the performance in the control room. On large
stages, the SGI allows a guitar signal to travel
from the wireless system to a pedal board and amplifier.
The SGI employs a proprietary drive and balancing
circuit that is made up of two modules: the SGI-TX
transmit module and SGI-RX receive module. The SGI-TX
is active with 100% discreet class-A circuitry and
Drag™ control load correction to ensure the
most natural sound. The SGI-RX is completely passive.
To eliminate hum and buzz caused by ground loops,
each module is equipped with isolation transformers
that are wired in opposing directions to counteract
any artifact. Best of all, the SGI is plug &
play easy to use and comes equipped with power supply.
SGI Setup: Plug a
standard 1/4" guitar cord into the
SGI-TX input. Plug the TX 's low-Z XLR output
into one end of a standard balanced mic
cable up to 300 feet long and the other
end into the SGI-RX receiver module's XLR
input. The standard 1/4" output of
the RX connects to your amp, mixer or effects.
Dial up the perfect pickup loading for your
guitar with the TX's Drag™ control
and use the RX's ground lift switch if you
need to eliminate any hum or buzz.
... Now you are all set to enjoy playing
guitar in the control room while your amp
setup remains on the sound stage, hundreds
of feet away, with perfect guitar sound
and zero signal loss or degradation.
